Activity

Great – thanks!

That’s all good with me! I hope it helps

Thanks!

Hey Matt,

I would love to see a video or just pictures of how you attach your seat. I just finished up the new 2 piece seat and I’m having a hard time visualizing how to attach both parts to one point in the back. I saw in the directions that you’ve used webbing and buckles and was looking to go in that direction.

Thanks!

This is great – thanks! If it’s okay with you, I’ll copy these pictures to the instructions page and give you a shoutout there so more people will see it.

The freezer might work – I haven’t actually tried it, but Gear Aid does recommend storing opened tubes in the freezer.

I usually toss the screw-on brush after the first use, and then I re-use the metal-handled brush even if it’s totally hardened, but in that case I use it more like a spatula. Sometimes I just use my finger to spread the sealant…[Read more]

I made a couple forms that are basically the point on your form pattern isolated into a little handheld piece. This ended up working really well for me and I managed to get the whole bow sealed without any wrinkles to speak of. Thanks for the encouragement and feedback!

Dimensions are in inches, but they’re just estimates, I took a block of wood…[Read more]

Ah, clearly reading isn’t my strong suit, but yes. I didn’t want to change the shape of the bow, and while the nose of the form was about the right shape,  I just couldn’t get the fabric on there in a way that it didn’t want to wrinkle where the seam tape was already attached to the tube material.

I’m certain the way you describe works, I think…[Read more]

I meant, did you read the section below the video with the heading “Ironing around the pointy bow”?

Matt, I watched that video over and over. I tried every bowl I had in my house and a couple I picked up from the thrift store. I’ve been really impressed with your instructions (honestly, this one too, I think this is more of a “me” problem), this time I just couldn’t get it right. I’m going to make some smaller forms and play around on some…[Read more]

Just to make sure, did you see the “Ironing around the pointy bow” section on the instructions page?

It’s okay to have a few small wrinkles towards the edges of the seam strip there, so don’t stress about it.

I know your pain! LOL I built a Telkwa and the nose and stern are equally difficult. I ended up with 8 different wooden forms and used a 3 inch diameter hard rubber ball with tape with the sticky side out to do the nose and worked well.  It takes time and I ended up with a tiny wrinkle but was able to iron it out to almost nothing. So don’t gi…[Read more]

Sure, send me an email if you’d like to order a replacement piece.