Thanks!
I will defently add it after its finished. One downside of it will be that it kind off get in the way of stored gear but i guess it wont be that much of a downside if its located towards the front. I also have to be aware of not interfearing with the tube-floor joint with the bottom attachment (or do an attachment loop upon putting it together).
Yes, I understand that a round pipe shape transforming to a flat in 90 degrees can be tricky and was thinking of making it octagon, square or flat shaped.
I think i will make a classical shaped dry bag for practice, then I can just patch it up later and not let the material and work go to waste
Can you glue an attachment loop to the non-TPU side, or do I have to make the bottom attachment through the tube floor and heat seal on the outside?
Here is an ugly concept sketch for an easier understanding of what I want to do.
