Forum Replies Created
-
Replies
-
This is the point where I have the problem. The blue rectangle is firmly attach to the floor, but the red rectangle is where there is not TPU either side because I patch a piece of fabric on top of it (because I cut the first 4cm as they were on the wrong side). The red area is where I can’t stick anything, and the problem is where there is joint 1-2L. The same red rectangle is highlighted on the floor plan in light blue.
The 3 sides where I circle in black are on the wrong side of the tpu, so nothing will stick on them. The red circle is the only side where I can stick the patch into the tube piece. That’s because I seal the piece 1L on the wrong side from the beginning (including the internal reinforcement strip). The green line means there is no TPU on either sides because I had to seal a patch on the end of the piece 1L (on the 45 degrees end) to be able to get the original shape/size.
