Activity

Is your Clover always too hot on the High setting? I’ve found that mine can get too hot if I leave it sitting on a stand for a while, but then if I rub it on some wood or something for a few seconds before using it, it cools to the right temperature. I think part of the problem is that the stand holds it with the tip slightly elevated, so hot air…[Read more]

Is your Clover always too hot on the High setting? I’ve found that mine can get too hot if I leave it sitting on a stand for a while, but then if I rub it on some wood or something for a few seconds before using it, it cools to the right temperature. I think part of the problem is that the stand holds it with the tip slightly elevated, so hot air…[Read more]

I bought the one that you reviewed on the site here, the Clover Mini Iron II. It gets the job done, but I’m not in love with it. The hot setting is too hot and burns the nylon. The medium setting works, but I’ve found that it requires a lot of pressure and a going back and forth over the area to get it to seal well enough. I got the narrow tip for…[Read more]

I bought the one that you reviewed on the site here, the Clover Mini Iron II. It gets the job done, but I’m not in love with it. The hot setting is too hot and burns the nylon. The medium setting works, but I’ve found that it requires a lot of pressure and a going back and forth over the area to get it to seal well enough. I got the narrow tip for…[Read more]

I’d like to see a paddle and a PFD.

Definitely some kind of srpay deck, that’s the only thing holding me back from ordering one right now. I would prefer a whitewater option but a cruiser spraydeck would be good enough for now 🙂

Left front, #1 piece.

Left front, #1 piece.

Left front, #1 piece.

Hi Larry,

A 1/8″ overlap won’t be a problem, so I recommend centering the piece in the available space without trimming it.

Out of curiosity, which piece is it?

Cheers

Hi Larry,

A 1/8″ overlap won’t be a problem, so I recommend centering the piece in the available space without trimming it.

Out of curiosity, which piece is it?

Cheers

Hi Larry,

A 1/8″ overlap won’t be a problem, so I recommend centering the piece in the available space without trimming it.

Out of curiosity, which piece is it?

Cheers