Hello!
Currently building my first V3 raft and couldn’t be more excited! I believe this question was posed before, but I did not completely understand the answer. I recently heat sealed both sides of piece L3 to the floor and am ready to seal L4 down as well. For some reason L3 came up about 1.5cm short of the corner. From what I can gather it’s not a huge problem, but I’m not sure how to allign L4 with L3. Do I place L4 on the predetermined location labeled on the floor and have a 1.5cm gap between pieces? Or do I allign L4 next to L3 so the edges are touching? I feel if I do the latter there will be a countinous gap down the line which may or may not be an issue. If I place L4 in its corresponding place will I need to do something special to make up for the gap? I can post pictures later if need be.
Thanks a ton, I love the idea of DIY rafts. It’s a cool thing you are doing.
-Logan
