[Blair]

Thanks Matt, I figured it was fine but wanted to double check.

The iron is up to max, so I think I’m moving a bit slow, I suspect I may need more practice to find how quickly to move.

[Blair]

I figure instead of starting a new thread I would tag onto this one.

I’ve been doing some testing and I can heat seal the tube fabric to the flooring (1000D I think), but the heat seems to be coming through a little to the underside of the flooring. If it put more tube fabric underneath the floor it kind of sticks, but in a way that there was clearly not enough heat and both sides pull away cleanly. The TPU doesn’t look at all melted, just heated.

I don’t think this is a problem, but I wanted to check to be sure. Is this fine?

[Blair]

Hi, I bought a v3 kit  2 and a half years ago and have finally found time to work on it.

[Author]

Replies