[sldrose]

inner reinforcement

[sldrose]

Thanks Matt,

I managed to reheat and separate the fabric. The TPU did separate in some places. I assumed that this means that it wont reseal??

Can you reseal TPU once if the TPU has lifted?

I wasnt sure if it would re-hold, so I reinforced with a second strip.

The inner reinforcement strip is attached to the base and to the non-tpu side of the tube.
Will the TPU side bond with the non-TPU side of the tube?

I’ve run into this situation a few times and i’m unsure if i should use TPU to non TPU side or seam-seal glue. Do you have a preference for strength?

thanks

Sean

p.s. im really enjoying this project. I have an appreciation for what you would have gone through to figure this out without instruction.

also, i tried the bowl and the form, but neither worked until i had the double sided masking tape on. It made all the difference.

cheers!

 

 

 

 

 

 

[sldrose]

thanks Matt,

do you have any links or instructions on how to construct these forms?

(i had a quick look but couldnt find anything

[sldrose]

hi

just ordered the v3 kit and irons

Living in Calgary, Canada but originally from Australia.

I’m really looking forward to building this.

Great site Matt, I can finally get into packrafting!

cheers

Sean

[sldrose]

30 min or seconds?

[sldrose]

Hi @brucecampbell ,

Just double checking that you are in north America?

The second two links (with the better cords) only seem to come with uk/euro plugs
and suggest that when operating at 110v the temperature range is max 130deg Celsius.

Do you think these are the same as your unit?

The description in the first link (the one you bought) just says 220v and doesn’t list the type of plug supplied.

Just trying to make sure I don’t buy the wrong one, and that it reaches the correct temperature.

Do you think I should just get the one that you bought to be safe?

 

thanks

Sean
Calgary, Canada

 

 

 

 

 

 

 

[Author]

Replies